![]() ![]() It however works correctly with ECU communicating.ĩ December 2020 Version 1.1.0.5 (Note: version 1.1.0.4 was only released as beta) This could, depending on message timing result in the hobbs counting at about 1/4 rate. This is sent every 4 seconds but the timeout was set to 3 seconds. In order to prevent this from triggering hobbs this RPM is ignored but only in case a certain messsage is received on the CAN bus from the RDAC that is only sent by these RDAC versions. With engine ECU off the RDAC sends a RPM of 9001 as easily visible indication. There is also a function to popup the audio control panel on the screen via switch.įixed a small issue related to using RDAC units for 91xiS and ULP engines. ![]() ![]() COM1,COM2 Audio On/Off, COM TX selection and phone answer/hangup. Fixed issue with negative UTC offsets.Īdded option to select larger traffic diamonds on maps (under traffic monitoring setup menu).Īdded digital input functions to allow control of some audio panel functions via switches. Black box RS232 data feed is now permanently enabled and no longer based on an active flight which makes it easier to use for HUDs etc. It has been a while since the last update, This version release includes several relatively minor additions including screen designer functionality for Throttle position - mostly for the ULP range of engines. This release also contains support for the MicroKit Wifi interface (flightplan upload) Increased Watchdog timeout interval to prevent system restart if card storage operations take longer than usual.įixed minor issue - when entering latitude in waypoint editor while using decimal second format it would double the minutes as entered. Note: Use with care and should only be enabled if fuel level readings are reliable and repeatable. Details of current firmware upgrades since first release:Īdded support for Microkit Wifi interface to HS RS232 port 1 on iBOX based iEFIS systems (RS232 port on rear of panel).Īdded selectable fuel level alarms (similar in function to engine related alarms). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |